Paravision SX1 connector board

[ulysses31]

hi,
i dont know if this is the right place to post this but..

i just got one of these nice and cheap but it did not come with the connector board.
i used to have one of these but got rid of it, i know it is not as good as the sx32 pro but it didnt cost a fortune.

ok, so does anyone know where i can get one or maybe someone here has one to sell?
sorry if this is in the wrong forum

oops i meant the connector board :roll:

[madsjm]

Sorry for asking, but what is the pass through board?
I own an SX-1 myself, but I don't think I have that board..?

[tonyyeb]

ulysses31 wrote:
hi,
i dont know if this is the right place to post this but..

i just got one of these nice and cheap but it did not come with the connector board.
i used to have one of these but got rid of it, i know it is not as good as the sx32 pro but it didnt cost a fortune.

ok, so does anyone know where i can get one or maybe someone here has one to sell?
sorry if this is in the wrong forum

oops i meant the connector board :roll:

Did you get it from ebay? If so I saw that auction and stayed away cause I thought the missing connector was going to be VERY hard to get... unless you can find a compatibly replacement at RS, CPC etc...

[ulysses31]

yep i did,
but only because I knew that I had a spare connector here.....
BUT do you think I can find it now :madashell:

will this be a straight edge to edge connection?
I could knock up a lead, but i would rather not.

i suppose i should have found the connector before buying it, although I did turn up another SX1 here with a couple of chips mising but still no connector


the edge connector has approx 1.27mm spacing so i could always use a couple of modified dimm sockets and a small pcb (or wire).
just need to know the edge connectors pinout now

[rkauer]

 Here is the pinout for the CD32. You can track the voltage rails from it to the SX32/1 board to achieve the correct connection.

 Hope it helps.