Viper 1230

[caver99]

I have installed a second memory slot into my viper 1230 is there abything else that need to be dont to get the second slot to work, i have tryed some working ram in it but wont boot unless i take it out?

[rkauer]

 What Viper you have? There is bunch of 'em. Not from the same company (Elbox, DCE, Apollo, others).

 Some (2) have provision to solder a second SIMM slot. If your board is the DCE Viper mkII, check just for cold joints in your new SIMM slot.

 If the M-Tec E-Matrix (also rebadged DCE Viper MkV), look if you install the correct SIMM holder.

[Flash]

Hi,
I also have a Viper 1230, as far as I know it only accepts upto 16mb of memory. So two 8mb simms would work but not two 16mb simms

Yours Flash :rtfm:  :rtfm:

[caver99]

I have the m-tec badged one and i have fitted the one from here http://amigakit.leamancomputing.com/catalog/product_info.php?cPath=25&products_id=594&osCsid=a3ed726eaa769a33c6ca4fa67cd68212
its the angled one, was wondering if there were any solder pads to check

[Acill]

Back when I had a 1200 i got one of these cards. I thought it was dead after I put in 3.1 roms and it no longer booted my system when installed with RAM on it. I was later told the card didnt work correctly with 3.1, this could be thr problem?