update on my neobitz

[TheGoose]

Well, I have it going on my a1000 and works sort of but very unusable for some reason(s)?

I have a shaky picture. And the colors are off. I double checked my RGB connection just like in the youtube video and they are just like his.

I have a s-video connector just like his, bought it from Mouser electronics (really good shop BTW) so those wire leads are connected to the out header wires from the kit. I grounded all the grounds to the MB.

What could be at fault here? My composite out on the machine still works fine too, hmmm.

Maybe I half blew up the neobitz board? Or my tv does not like it? It's a non-HDTV LCD by Sylvania.

Wild interference? The cover is still off.
 

 :-?

[rkauer]

 Use shielded wires for the signals. Ground the braid of the cables just in one end to avoid more interferences.

 And one more tip: some LCD TV/monitors (the vast majority, unfortunately) don't sync if the screen is lower than 56Hz (if you are using PAL resolutions).  :-(

[TheGoose]

Thanks rkauer, I'll look for something like that, or maybe try an rigged experiment with foil just to see.

I might look into a more quality & shielded s-video cable itself, this one is el cheapo.

I do think this is 'noise' issue - so close....