Any users of the Harms Professional 030 A500

[lillPiP]

Need help!
When configuring the ram it adds the ram but shortly hangs.
Running the card without adding the ram in workbench works OK. Both my cards behaves like this..

[amiga92570]

Make sure you are not mixing the zip sizes. All must be the same.

[lillPiP]

All my zipmemorys has this text on it:
MCM5400AZ70, JAPAN SCZCZ9406
I have 16 of these. Would that give me 8 MB of ram?

[lillPiP]

Anyone?

[lillPiP]

Please? Someone else must be using thìs card? :-)

[rkauer]

lillPiP wrote:
All my zipmemorys has this text on it:
MCM5400AZ70, JAPAN SCZCZ9406
I have 16 of these. Would that give me 8 MB of ram?

 Sounds you have 8Mb in it. But check for a bad/burned chip (i.e. : remove all and put back a pair at a time). Turn the Amiga on each time you add a pair of chips and see what happens.

[RW222]

off the top of my head, I think those are 4Mbit chips so yeah, 16 of them should give you 8MB

[Chain]

i will suggest to run some ram test utility, in example microbotics ram test 1.2. there can be few cells damaged by heat, age etc

[leirbag28]

QUote:
Any users of the Harms Professional 030 A500


Nope! They were all "Harmed" in the process of using these.

:-P

[lillPiP]

Ok,
I tested to activate the memory without any harddrive controller. Copied a few mb's to the RAM: and it worked OK.
But as soon as the harddrive is activated and the memory is configured the machine hangs.
I have also tried to change the MASK on the harddrive to 0x1FFFFE so it will only use the DMA to and from the chipmem only. But neither this works....help!