Hello,
I got some questions considering the RGB of the CD32.
I added an RGB output on my CD32 considering
this page. (though I haven't soldered the resistors yet)
I've got an Amiga 500, an Atari Jaguar, a SEGA Master System and Megadrive attached to a commodore 1084S rgb input. These are all connected at the same time, no switch between it. This worked fine, until I attached the rgb output of the CD32 on it.
When I attach the cd32, the megadrive won't display anything, unless I disconnect the gnd of the RGB output of the CD32 (but then, the sync is a bit distorted, horizontally).
The Amiga 500 has some interference (dark/bright horizontal interference) in it's video output.
However, the CD32 itself gives a fine, clear image, as does the Jaguar and the master system.
I can't imagine 47ohm resistors can solve this problem. Also because the site states these must placed on the colour output lines, not on the composite sync).
The only thing I can think of is that I have put pin 174 directly on the ground, not on the "u36" as stated in the source (I found out that u36 is a chip, and it's not clear to me which pin is ground).
Could anyone help me? Thanks in advance :-)
