hi,
I put a hd in my a600 a 40mb seagate and ran hdtool box on the install disk partitioned 2x20mb partitions then formatted them installed wb2.1.
But the hd wont boot I get the purple screen asking for a disk so i put in the install disk but it doesnt show the hd until I run the hd setup again click on partition hd where it shows the hd under installed hd in system.
I cancel the partitioning and return to the wb screen and the workbench and games drawers are visible then but if i reboot the purple screen appears again asking for a disk any ideas.
It was working fine in my a1200 which I upgraded to 1.5 gb drive which incidentley i tested in the a600 as i was going to use it with whdload but as it only has a 2.0 something rom it wouldnt recognize the entire drive but it did boot.
Any ideas thanks.
