Mount ADF as volume in AmigaDOS 3.1?

[blakespot]

Is there a program that will allow an ADF to be mounted and accessed as if it were a physical disk in 3.1? How about 1.3? Thanks.


bp

[mindprober]

Not sure about WB 1.3 but this will work with 3.1.

Perhaps not with a single program, but you can do it with two:

http://aminet.net/package/disk/misc/fmsdisk

(to mount a virtual floppy)

and then write the .adf with:

http://aminet.net/package/disk/misc/tsgui

[amigakit]

Hi

EasyADF will do this function.  You select the ADF then destination device as RAD: and click Write Disk button and then it will mount on the Workbench screen.

Hope this helps!

[kolla]

Ignore all other answers and use this:
http://aminet.net/package/disk/misc/diskimage.m68k-aos

[LoadWB]

Ignore all other answers and use this:
http://aminet.net/package/disk/misc/diskimage.m68k-aos

YUP!  This is what I was looking for to tell him.  I have it installed but forgot what and where I got it.  You can mount all kinds of images, even D64s.

[bbond007]

Is there a program that will allow an ADF to be mounted and accessed as if it were a physical disk in 3.1? How about 1.3? Thanks.


bp

This is what i use, but it says you need KS 2.04 minimum

http://aminet.net/package/util/rexx/isomount124

[pyrre]

:bump:


Im bumping this because i am in the prosess of backing up (at least some of) my disks. And i would like to have a tool to mount .ADF images as DF1 to use disk copy programs to back up disks....

Is this possible?
or should i just get a goteck?

[Thomas]

Use diskimage.device as suggested above and just rename IDF1 as DF1.

[nyteschayde]

Ignore all other answers and use this:
http://aminet.net/package/disk/misc/diskimage.m68k-aos

Agreed. This is the one you want.

[nyteschayde]

For reading and writing ADFs from and to physical disk, respectively, this package, as mentioned above, is fantastic.

http://aminet.net/package/disk/misc/tsgui

[vince_6]

In the past I used transdisk command line to make some adfs but I always preferred the old DMSII GUI as it gives images below 900KB.

Nowadays I made 2 button scripts on my old DOpus to make/extract both adf and dms.

[Reido]

Hi

EasyADF will do this function.  You select the ADF then destination device as RAD: and click Write Disk button and then it will mount on the Workbench screen.

Hope this helps!

Didn't know about this, thanks!

[mark_k]

Also check out the XFileSystem package. It can do a lot more (reading/writing various alien floppy formats), but includes file.device. You can press a hot-key combination to open a file requester then choose an ADF to mount.