Does anyone currently have one of these installed?
If you do, do you have a photo of where you have soldered the two wires?
I've had a look at the website and it mentions:
Quick info about four header pins next to the IDE-connector:
|oooooo+O IDEHEADER...........
|oooooo-I 1stIdePIN...........
|
|
Poor quick and dirty "diagram" show a part of pcb at a corner.
2*6 pads/holes symbolised with 'o' are card edge jtag contacts
+-OI are four header pins
+ - are LED positive and negative terminals
O = /OVR
I = /INT2
If I look next to the IDE header there is the HDD led then there are 5 pads not 4. Do I solder two wires to the first two pads?
Assuming left to right from the IDE header it's /OVR then /INT2?
and on the Amiga left to right it's /OVR then /INT2?
:-)
