I just purchased a Super Gen and Super Gen SX, but have no manuals.
My question is if anyone has the manuals and can scan them for me, or if they could answer a question for me...
What I need to do is plug one of these into my new Chroma Key +. The Chroma Key plugs into the RGB port of the Amiga. The plug has a pass through port in which the Super Gen is supposed to plug in. Now what I want to know is if the RGB ribbon attached to the Super Gen is the part that plugs into the back of where the Chroma Key + plugs into the Amiga or if I am supposed to buy a 23 pin to 23 pin cable and use the Output Port below the cable.
Refer to image:
I'm assuming the plug under the Ribbon goes out to the monitor, that would make the most sense but I want to be sure before I try anything.
Also have any of you used a Super Gen with one of Amiga Maniac's V3.1 RGB to PAL/NTSC Adapters? What were the results? Did you have to build a separate power supply for it?
Likewise, what are the odds of this set up working with a Indivision ECS Scandoubler / Flicker Fixer (Internal)? I presume you can only see the Input from the Chroma Key + through that, and need to use the RGB out or Composite out of the Super Gen to get the whole picture?
