Picasso II+ vid port confusion

[MrZoon]

Can anyone clarify which vid port on this card is the output and which is the input? I had this working for years, and then I disassembled the machine to do a repair on the mobo, and now I can't get any vid from either port. This is in an A3000, so it's either left or right (looking at the back of the machine).

I read something about a resistor blowing under certain circumstances, and I *did* switch to a different monitor. Could that be it? If it's blown, are there instructions anywhere on how to fix it?

Durnit...

[VingtTrois]

On PICASSO II:
Output to the monitor = connector near the screw (right if looking at the back of the machine).
Output to the AMIGA = connector at the left.

I suppose that the location of the video output connector of PicassoII & PicassoII+ is identical! Must be confirmed!

[MrZoon]

Thanks! I'm wondering if the resistor issue happens if you plug the cables in the other way, or if it's more to do with the type of monitor. Old monitor was a NEC multisync (I think?), "new" monitor is a IDEK/iyama (which works fine off the mobo video port on two different A3000s).

Thanks again

[orange]

afaik, if resistor is blown, it IS fixed!
resistor supplies voltage to monitor, that is not needed. here is some info:
http://eab.abime.net/showthread.php?t=51133&highlight=picasso+resistor
http://eab.abime.net/showthread.php?t=55221&highlight=picasso+resistor