New 3.1 install locks computer when inserting floppy disk!

[tbarzso]

I have an a2000 rev.6 motherboard with a GVP 040 card.  I recently installed 3.1 ROMs, and the machine booted and functioned fine with the ROM and the old 2.0 operating system.  I installed 3.1 from floppy disk, no problems, then rebooted.  Now, whenever I insert a floppy disc, the system completely locks up.  If I boot the system with a disc already in a drive, it works and reads normally until I either eject it or insert a new one.  If I boot from the Install disc, I get the same problem, but not if I boot from the actual WB 3.1 disc.  This is bbviously a software problem, but not sure what.  Any suggestions, other than trying to wipe the entire HD and start from scratch?  has anybody encountered this problem?  Thanks!

[Oli_hd]

Sorry but this is going to be a short replyg, have you installed the 68040.library from the GVP disk? (Or any 68040.library) If not try that.

[tbarzso]

I had the 68040 card up and running with GVP drivers before the upgrade, but maybe I should try a re-install after the fact.  A couple other things have been acting weird since the installation, so I may have some hosed drivers/libraries.  I do seem to recall the 3.1 installer installing a 68040.library...But I'll give it a try.  Thanks!