Author Topic: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200) (Read 1212 times)

keropi · « **on:** December 05, 2005, 09:30:08 AM »

OK, I discovered that the volume settings of the Terratec 128i which is plugged on my g-rex are not effective immediately after the os loads, I noticed this because I have connected the paula output to the line in of the terratec, and when I run some whdload games I had no sound... if I just open the volume control prog, the settings get applied and there is sound from the line in... is there a way perhaps to put the volume control in startup-sequence? :-?

keropi · « **Reply #1 on:** December 05, 2005, 10:06:25 PM »

noone? there is no way to do that? :boohoo:

RacerX · « **Reply #2 on:** December 05, 2005, 10:21:43 PM »

With OS4 you'd add "mixer setlevels" to your user-startup. It might be something similar with your set up.

djbase · « **Reply #3 on:** December 05, 2005, 10:37:33 PM »

If I remeber right I just put the mixer in WBstartup with cx_popup=no as tooltype.

keropi · « **Reply #4 on:** December 06, 2005, 07:29:10 AM »

Quote

DJBase wrote:
If I remeber right I just put the mixer in WBstartup with cx_popup=no as tooltype.

Thanx DJBase! it works! :-D

Author Topic: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200) (Read 1212 times)

keropi

How can I make the volume settings of the soundcard to apply on boot? (G-REX1200)

keropi

Re: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200)

RacerX

Re: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200)

djbase

Re: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200)

keropi

Re: How can I make the volume settings of the soundcard to apply on boot? (G-REX1200)