Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: A3000 resurrected.  (Read 1483 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline T3000Topic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 617
    • Show only replies by T3000
    • http://www.rcfreas.com
A3000 resurrected.
« on: September 08, 2004, 03:15:39 AM »
Replaced the battery, reinstalled the os, run setbatt to fix the scsi amnesia, and am reinstalling programs. Hope it all works now.
Logged
 

Offline TjLaZer

Re: A3000 resurected.
« Reply #1 on: September 08, 2004, 04:29:52 AM »
My 3000 also had a leaking battery.  Was causing some Amber issues, I cleaned it up and she works fine now.  I just have to remove the MB and place a new battery in her now!  Did you remove the MB to install the batt?
Logged
Going Bananas over AMIGAs since 1987...

Looking for Fusion Fourty PNG ROMs V3.4?

:flame: :banana: :banana: :banana:
 

Offline Failure

  • Lifetime Member
  • Sr. Member
  • ****
  • Join Date: Jun 2004
  • Posts: 332
    • Show only replies by Failure
    • http://awhitlock.net/
Re: A3000 resurected.
« Reply #2 on: September 08, 2004, 04:44:05 AM »
I removed the MB in mine, since I was getting the INT-2 hack done as well.  It is easier to get the battery replaced with the mobo out, but I think it is not necessary.

Congrats on getting your 3000 resurrected, I just finished putting my CSPPC one back together last week :-)

*edit* and doing the battery in the 3000UX once I get the next replacement from Red...
Logged
You can\'t spell evil without "vi"
AMIX Wiki | AmixBP
 

Offline T3000Topic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 617
    • Show only replies by T3000
    • http://www.rcfreas.com
Re: A3000 resurected.
« Reply #3 on: September 08, 2004, 05:55:20 AM »
Easier to solder on the MB without the chassis in the way.

Before I dismantled the system, a trace in the MB burnt. I thought it was done for but the A3000 kept running for a few minutes before I shut it down and stripped it apart. Luckly the trace that burnt was short and not in the middle of other stuff. Cleaned up the burnt area and soldered a new wire in it's place. Didn't take a pic after I fixed it but here's one before.
burnt trace

So far so good...

hmmm   Guess this should have been posted in the hardware forum... :hat:
Logged
 
Pages: [1]   Go Up
« previous next »