MakeCD 3.2 problem

[amigagr]

i had a similar problem recently and after a clean install from scratch of the makecd all problems gone. i use the standard a1200 ide port though...

[amigagr]

@Boot_WB: in my setup i have set the speed at 1x but the prog writes by it's self from 6x to 8x...

[amigagr]

in a3000 with the standard scsi controler, when i'm setting the speed at 1x writes at 1x. in a1200 dosn't work. i have try to write both image files and direct files from a partition (i.e. System). when i'm writing files from the partition the burn process is faster. in any case, i only have the standard ide port of the a1200.

[amigagr]

i'm writing ok at 8x with a 52x32x52 cdrw. i'm using scsi.device and not atapi.device as i did in the past because i noticed that with scsi.device the cd can write at faster speeds. the cdrw is connected as slave at the standard ide port of a1200

[amigagr]

bakoulis wrote:
What specs have your amiga? Mine have 040 blizzard but
it fail to keep the buffer full.

a1200, bliz1260/50, 192mb ram, 60gb ibm hd, subway usb, 150w psu, pcmcia ethernet, cdrw lg 52x32x52, amiga os 3.9 bb2.
it was writing ok too in the past with 32mb ram, 4gb seagate hd, os 3.5, and cdrw sony 12x.

[amigagr]

bakoulis wrote:
I thing the 060 is enough for 8x writing but my 040 isn't.
Plus my 8GB 2.5 hd is only 4.200rpm.

i don't know about cpu speed problems but i have to say that from the moment that i start to use scsi.device i'm writing cds on the fly and not cd images as i do it in the past with atapi.device. as for the hard disk, sysinfo reports 1.8mb/sec transfer rate on my hard disks (the old and the new i use now)

[amigagr]

bakoulis wrote:
The BTC is the problem is my opinion. What to you mean "makecdromfs.module"?

makecd 32c update makecdromfs 45.12