Author Topic: Scandoubler problem (Read 3546 times)

amigagr · « **on:** May 09, 2006, 04:26:45 PM »

i have the same mobo and it works fine all these years. i have test it with this scandoubler and it's ok. your problem is somewhere else.

amigagr · « **Reply #1 on:** May 09, 2006, 04:48:27 PM »

a500 psu is not enough with the hardware you already have pluged...

amigagr · « **Reply #2 on:** May 09, 2006, 05:05:04 PM »

can you conect the amiga with a normat 23pin cable to somwhere else, tv set for example with scart, to test if the amiga's rgb output is ok?

-edit-
ok i see you already have write about it.

amigagr · « **Reply #3 on:** May 09, 2006, 08:05:01 PM »

how do you power up your amiga? the amiga rgb port gives -5 volt at pin 21. is your psu gives this voltage to the amiga? are you using a proper amiga psu or something from pc world? maybe the scandoubler needs that -5 volts.

amigagr · « **Reply #4 on:** May 09, 2006, 08:16:55 PM »

i think that the other 2 maybe can work with it. i test mine on my proview 17 flat monitor (30-98khz 50-160hz). it's fine.

amigagr · « **Reply #5 on:** May 09, 2006, 08:26:44 PM »

you are talking about a diferent scandoubler. i and SuperTurbo talking about the same scoundoubler which (mine) Matthew at amigakit test it at his a1200 too.

amigagr · « **Reply #6 on:** May 09, 2006, 08:52:15 PM »

you are absolutly right but meanwhile and so far we (all here) adding some thoughts/ideas in progress based on the facts, trying to solve this issue. of course as you can understand some of them are faults hopping someone finaly will hit the right answear :-)

amigagr · « **Reply #7 on:** May 12, 2006, 10:50:48 PM »

:laughing:

Author Topic: Scandoubler problem (Read 3546 times)

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem

amigagr

Re: Scandoubler problem