SCSI HDD not seen unless IDE HDD connected

[amigagr]

motorollin wrote:
I have just got my SCSI hard drive set up on my Blizzard 1230, and have migrated all my files from my IDE drive to the SCSI drive.

Piru wrote:
You forgot to put the filesystems to SCSI drive's RDB.

but how can you format a disk/partition and move the files in if the disk has not got the rdb? everytime i use hdtoolbox to setup a new disk after the installation of disk hdtoolbox put by it's self the ffs on the rdb. only if you go manualy can change the setup of partitions and rdb to something else.

[amigagr]

and reformat and put files once again :lol:

[amigagr]

hmmm, let's hope.

[amigagr]

Flashlab wrote:
I rad here somwhere that putting SFS on boot partitions could cause trouble.

i use only sfs at both of my amigas in ide and scsi disks with no problem at all :-)

[amigagr]

waste of time but... it's your decision

[amigagr]

@Thomas: what is your opinion on sfs v2x? have you try it?

[amigagr]

if you install in rdb a file system (any file system) any program that need it can use it from rdb, no need to search for L: directory. the meaning of ''go to L: to load the file''
is just for the installion at the begining, i think.

[amigagr]

i have no problem to buy it if it's realy the best and if i can find any site/saler where i can buy it  :-)
anything to suggest?

[amigagr]

motorollin wrote:
just booted with no startup-sequence and ran setpatch, so I don't see what the difference is.
moto

but the ss is not only setpatch it's a lot more. other patches/tools/drivers/ etc. i wonder what did you expect with the use of only setpatch.