Advice on best A1200 accelerator

[Snoozy]

Oh no what have I done!
Can u give me ur s:start up sequence!

[Snoozy]

Hi guys,
 
i need a little more help with my s:start up. I have edited s:start up by inputting C:ACATune..etc command line into the first line of my s:startup and my aca1230 card is recognised fine once wb loads..problem is wb doesn't load from cold start..it starts up but the screen goes blank (as if going into a reset mode) and then the system hangs on black screen. So i then do a soft reset and it works normally with ACA card recognised. Anyone know what is happening here? FYI my s:startup is very standard apart from the ACATune line i inserted at the beginning.
 
Another question! My PCMCIA port recognises my 2mb pcmcia ram card but no longer recognises my PCMCIA CF adaptor :cry:
 
Why is my 1200 so tempermental :smack:

[Snoozy]

If i can get my pcmcia sorted i will copy and paste my s:startup onto my cf and then paste it onto here if that is possible

[Snoozy]

Maybe i should just buy the 3.1 rom chips and put on a surgeons mask and gloves and attemp the transplant ? :laugh1:

[Snoozy]

Do you think i would need one of these...
 
http://www.ebay.co.uk/itm/IC-Extractor-Tool-IC-Removal-Tool-IC-Remover-Tool-/270508640829?pt=UK_Home_Garden_PowerTools_SM&hash=item3efb924a3d
 
or would a long flat bladed screwdriver be ok? hmmm do you think i would need to remove the motherboard again ? :nervous:

[Snoozy]

What did you use to remove them? Maybe i could try my chrome wheel nut cover remover from my car :roflmao:(it has little lips at the end to help pull off!!)

[Snoozy]

There's a significant improvement in the speed of the 1200 But i haven't had as much time to play WHDLoad because of other committments
 
Do you think the problem could be the jumper on the accelerator board, ie. now that i am kicking to a 3.1 rom i should now remove the jumper?:confused:

[Snoozy]

Runequester, why would you need to do the soft reboot if you have the 3.1 roms already installed ?