Is it possible to use SSD's with CSPPC? I got myself a sata to scsi3 adapter and might try using an SSD with it. Is there anything to keep in mind when choosing which ssd to use? I had been using ide to scsi3 adapter with a 120gb Seagate ide hdd and was achieving around 35mb/sec transfer rates as far as I remember. What's the upper limit with CSPPC?
About termination... I had been using the Acard SCSIDE set to "termination on" and did not have any issues with just one ide drive. (my scs cdwriter was connected to A4000Ts scsi2 port) Now if I plug 1 ide hdd, 1 sata ssd, and a scsi2 cdwriter converted to 68pin what should the configuration be like? I also got myself a cable with active termination at the end. (Previously I was using an ordinary cable with one ide device)
If you have more than one device as you describe with the ACard - remove the two jumpers from the ACard and put active terminators on each end of the cable. Then it will work - I have that config
