Welcome, Guest. Please login or register.

Author Topic: Marpet Deveopments M1207  (Read 2773 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline nicholasTopic starter

Marpet Deveopments M1207
« on: May 16, 2011, 03:28:36 PM »
I have one of these with 4MB RAM and I also have an MC68882FN25A.

The card works perfectly without the 68882, but when I fit the PLCC my A1200 just stays on a grey screen when I switch it on.

Any ideas chaps?
“Een rezhim-i eshghalgar-i Quds bayad az sahneh-i ruzgar mahv shaved.” - Imam Ayatollah Sayyed  Ruhollah Khomeini
 

Offline nicholasTopic starter

Re: Marpet Deveopments M1207
« Reply #1 on: May 16, 2011, 03:55:45 PM »
Quote from: Franko;638138
I know this might sound obvious but are you sure both the crystal and the FPU are in the right way round... :)

Chip is, but dozy me didn't think to buy a crystal! lol

Any particular one I need?
“Een rezhim-i eshghalgar-i Quds bayad az sahneh-i ruzgar mahv shaved.” - Imam Ayatollah Sayyed  Ruhollah Khomeini
 

Offline nicholasTopic starter

Re: Marpet Deveopments M1207
« Reply #2 on: May 16, 2011, 04:44:53 PM »
Thanks Franko, much appreciated.

I'll buy that crystal later.

Jumper is currently set to INT.  Which way round is the correct way for the PLCC chip to be fitted?
“Een rezhim-i eshghalgar-i Quds bayad az sahneh-i ruzgar mahv shaved.” - Imam Ayatollah Sayyed  Ruhollah Khomeini
 

Offline nicholasTopic starter

Re: Marpet Deveopments M1207
« Reply #3 on: May 16, 2011, 05:34:33 PM »
Quote from: Franko;638164
In the close up picture above, the FPU should be keyed to the bottom left corner of the socket (where the round hole is just above the word CPU) but it should only be able to fit in one way, hope you haven't forced it in the wrong way... :)

PS:any luck with the RetroBright yet... :)

I've got it fitted that way but still stuck on a grey screen. :(

RE: Retrobright, on my third attempt at i left it under a proper UV bulb for 10 hours without checking on it.  Went back at the 10th hour to find out the fuse had blown in the plug!

4th attempt tonight! :)
“Een rezhim-i eshghalgar-i Quds bayad az sahneh-i ruzgar mahv shaved.” - Imam Ayatollah Sayyed  Ruhollah Khomeini