How to mount ADF Files in workbench 3.9?

[Franko]

AISS is an environment to store, access and maintain toolbar images.

Basically, the images you see in the four buttons in this window is supplied by the AISS system.

[ATTACH]1003[/ATTACH]

I tried AISS once, gawd what a load of rubbish it was, hundreds if not thousands of tiny little images that your HD spends more time trying to access than actually doing anything useful...

best place for AISS was the trash to be honest...

[Franko]

Franko what would you use then?
Or is all your stuff on Floppy and Hard drive and not Adf'ed?
I normally don't worry about mounting them I just use adfblitz to copy them back onto floppy since I would want to keep the disks I unadf.
How are you getting the adf from the PC/Mac to your amiga? there are some PC tools to unpack adf's (can't remember them now but when I get home I will check)

Hmm... not quite sure what you mean...

I haven't used (or even seen) a floppy disk for about 10 years now, All of my stuff is stored on HDs, CDs & DVDs...

Everything including ADFs just get loaded into RAM: as I have 256MB of Fast RAM and most stuff runs from there...

I don't need to get ADFs from the MAC as I have just about everything ever written for the Amiga stored on the above as mentioned...

If I need to transfer something to the MAC from the Amiga or vise versa I just copy it onto an SD Card and transfer it that way, using the SubWAY USB device on the Amiga...

Not sure what you mean about unpacking ADFs on a PC as I've never used a PC...

Basically all I use the Mac for is the internet and downloading/uploading files to my site, everything else I do computerwise is done on the miggies...