Help with SCSI

[utri007]

Hello

I have a Trump card pro scsi controller.

Im trying to install hard drive to it, I have a two options.

Quantum Atlas IV 9,1gb 68 pin and HP 146 gb 80 pin SCSI drives.

HDtoolBox doesnt found them, I have tried without any other scsi drives connected.

Quantum has a typical ID jumpers, but also these :  Force se and no wide

http://www.tacktech.com/display.cfm?ttid=378

HP does not have any jumpers, but 50 to 80 adapter has following, syn, dly and mtr what ever they do?

Exactly like this http://images10.newegg.com/ProductImage/A4SR_130513290085312500GL5IaD0N5J.jpg

I ques that HP is lost case, too new for trump card, but any hints for Quantum Atlas?

[utri007]

Trump card actually works right now. I took a 4gb hp hard drive to it, from another amiga.

Trump card manual says that it doesnt need a terminator unless cable is long, something like 70cm. I dont have any active terminator or cables to use with them. Only 3 connectors per cable.

Currently I use cd drive as a terminator.

I ques that I try to set up those drives with GVP scsi controller and see what happen.

I did change a scsi.device name to correct one to hdtoolbox.

What about that "no wide scsi" jumper, should I put it on or not?

Thanks