Amiga 2000 hd problem

[utri007]

I got a Trump card Pro and 1gb IBM hard drive for my A2000. Amiga 2000 is REV6 with kickstart 2.04

Everything goes OK, when I boot without GVP Impact 3001 accelerator connected, but with it installed it doesn't boot from HD. Sometimes it boots when I press A + A + CTRL

GVP is quite old revision, so jumper guides on amiga.resource.cx doesn't mach 100%

I have GVP's IDE boot rom disabled
Trump card has a F1 ON SID2 ON, others OFF
IBM HD doesn't have any jumpers ON (tried many compinations)

Any help?

[utri007]

You are right, HD is shown when I boot from floppy.

[utri007]

This is a "new setup", trump card and HD are proven to work.

GVP Impact 3001 doesn't have a SCSI, it has a very very poor IDE. Max 1024 cylinders, not a RDB compatiable etc.

[utri007]

KS 2.04 is just fine.  I don't belive that 3.1 could make a diffrence. Both of these products are made before KS3.1.

But I have some thoughts, I was transferin file with AExplorer and it terminated twice. Both times also mouse's left button stopped to work, so could it be because dry condersers?

I made a test, I loaded all cards inside of it, GVP, Commodore bridgeboard and trumpcard, turned it on and let it be about a half an hour. After that it bootet just fine with A + A + CTRL

After all this amiga hasn't had anyt use maybe in ten years.

OR

Could this be a Zorro II address base problem? I have full 8mb on GVP and Trumpcard must require some?

J5 - memory address of CN7-CN10 SIMMs
ON - Zorro II address space (with 1 MB SIMMs only)
OFF - 0x01000000 (with 4 MB SIMMs only)