Author Topic: Using a PAL CD 32 in the u.s. (Read 2319 times)

SONOFPSYGNOSIS · « **on:** November 19, 2010, 07:29:49 PM »

Hello all. It is almost impossible to find an NTSC version CD32. I have had a few oppurtunities to get a PAL version, and was contemplating the possibility of buying one, and then getting a step down converter. I think this is rather expensive though. Ideally I want to also get a floppy drive so then I can use my Amiga floppy games on this unit as well. If anyone has any suggestions I would really appreciate your help very much!:confused:

SONOFPSYGNOSIS · « **Reply #1 on:** November 19, 2010, 08:59:15 PM »

I do have a u.s. Amiga CD 32 brick, but u.s. is 110, and PAL CD 32 units are 220 or 240V. I believe I would need a step down converter in order to operate the PAL unit in the u.s. I could be way off, often am. Any thoughts?

SONOFPSYGNOSIS · « **Reply #2 on:** November 19, 2010, 09:33:44 PM »

I do have an older PAL compatible Commodore monitor. So the u.s. power supply should run the European CD32? I guess I was thinking that the voltage difference would have to be addressed. If not, that is fantastic!

SONOFPSYGNOSIS · « **Reply #3 on:** November 19, 2010, 10:00:15 PM »

Thank you very much!!! That is what I had hoped. Time to break out the trusty 1084S!!! Thanks again to everyone for your help!!!!!:hammer:

Author Topic: Using a PAL CD 32 in the u.s. (Read 2319 times)

SONOFPSYGNOSIS

Using a PAL CD 32 in the u.s.

SONOFPSYGNOSIS

Re: Using a PAL CD 32 in the u.s.

SONOFPSYGNOSIS

Re: Using a PAL CD 32 in the u.s.

SONOFPSYGNOSIS

Re: Using a PAL CD 32 in the u.s.