Hi. I have no idea if this is soft- or hardware related, actually, but here goes:
I own a cyberstormPPC and a couple of old scsi2 burners (got a converter with the board). One is unupported in DAO by makecd (according to their manual), so finally I managed to aquire the yamaha cdr100 which they claim should work very nicely with DAO and whatnot. Problem is it does not. It crashes as soon as I press 'start', no matter if it is in test mode or not, with some "write failed blahblah code 800004" or something.
It burns TAO just fine, so I would blame the burner / makecd normally, but then I realized that makecd also crashes during finalisation (always) of vcd burns and that the new burner rejects any audio cd.
Is it possible to have it work as well as it does (I have an UW hd and used to have two old burners on) for a couple of years, if it is wrongly terminated?
Could there be some option I need to change for the device?
What is the latest cybppc flash? I forgot the thread but someone claimed to get a version above some number I also forgot, but checking mine I think it was lower, yet the one on dce-com.de is even lower.
I suspect it is the controller as it sometimes (although) rarely reports an 'scsi error' thingie in which it kindly informs me that I can throw some debugging to the serial port, if I like. I forgot what it said exactly but it became less frequent as I flashed the board from time to time, back when P5 existed.
Hope someone can help me out here - and I apologize in advance for the poor formatting and wording. It is four am here and I should have been to bed long ago
Sincerely,
-Kenneth Straarup.
