4xEIDE'99 ?

[mrmoonlight]

Hi is there an alternative to this 4xEIDE'99
Buffered IDE still like Amigakit used to sell a few years ago which was smaller  and compact and did not stand precariously up right just waiting for me to damage the pins that holds it .Brian.

[mrmoonlight]

Ya know, I've glanced at that product many times and never noticed that it stands on end like that. Does that even fit under the keyboard? Anyhoo, if it were me, I would simply lay it down using a cable like this....

http://amigakit.leamancomputing.com/catalog/product_info.php?products_id=712

Other than the mounting predicament, it appears to be a great product. Maybe give that cable a try - use different length for best suitability.

Hi sorry its very vulnerable as I found out when I have opened her up a few times the unit has gone over on one side only a small amount but it must have taken the pins with it and its got to the point now where it is not recognising it so it looks like a replacement EIDE 99 or I may have damaged the A600 but a cable would have probably helped so thanks my friend.

[mrmoonlight]

Well, all may not be hopeless... it might just be a cracked solder point on the IDE connector of the MB. again, if it were me, I would remove the MB and hit each IDE connector solder point with a soldering iron. Be sure to use flux, a clean soldering tip, and just enough heat and solder to melt each point and let them cool again.

Inspect the IDE interface connection and repeat on it too, if necessary - but I doubt there would be anything wrong on the interface unless you might have really whacked it.

Temporarily give it another try and see if this corrects the problem - if so, use a cable on the second go.

I know, MB removal.... what a pain in the A$$.... :hammer:

LOL Pain in the backside I will try it again lol just to make certain ,thanks again

[mrmoonlight]

I find when I was using one it would slowly fall over and loose the connection. Two little blobs of hot glue and it was fine.

Hi that's exactly what is happening to mine so I will have another go at sorting it out because it did work well .Brian.

[mrmoonlight]

Are these buffered interfaces worth getting with regards to a cheap and dirty ide speed up on the 1200? In real life use is it any faster than unbuffered on an 030?

 Hi well this brings me to another question do I really need one as I am only using a CD drive and a CF card so could I not just connect the two to the correct cable and make sure one is master and one is slave and if so where would I get the software from to run it all lol , Brian
 

[mrmoonlight]

Thanks to all for there help but I have to hold my hand up and say I wish I had tried the easy route to sorting out my problems with my 4xEIDE'99
because after all the trouble of checking and rechecking every thing I had a thought about the install floppy and tried my copy and low and behold I am now up and running and thrown the original install away and I am well pleased so thanks again and thanks for some very useful facts best wishes Brian.