My A3K is a rev 6.1 25MHz with 16MB page mode ram and he 2MB of chip; I have a DENEB and a 4GB SCSI drive installed.
SYSINFO V4 reports me as being .87 as fast as a stock A3K.
Can anyone provide insight as to why I'm not at least a 1.0 of a stock A3K?
I had this same problem once with my 3000, If I remember right it was something to do with the MMU burst modes I had turning on during the start up. I know that don't make sense as to why the CPU would be reporting slow speeds and it did not make any sense to me at the time either, but After turning it off things went back to normal. There could of been something else going on here as well because I tried multiple things to fix this, but It did eventually resolve itself. I have also found over the years that results vary depending on what version of sysinfo you are using.
