Who will be first??? Working MiniMIG v1.1

[Colin_Camper]

I am building one using a V1.1 pcb from Nusim.

I have 95% of the components but there are still a few that I am having trouble with.

I am using a cheap temp controlled iron with a .4mm bit and .3mm solder and a bloody big magnifying glass!

As soon as I finish I will post my component list with RS and Digikey part numbers that I can verify are good (In both the mechanical and electrical senses).  :-)

[Colin_Camper]

 

[Colin_Camper]

95% from Digikey
I think I got the wrong SD card.
The memory, FPGA and 68k are all slightly different.
I guess I'll have to suck it and see!

Nearly everything I got from RS was not really right. E.g. the VGA connector was just the shell, etc etc.

I have my components on a spreadsheet - when I check the components I put a P for physical fit and an E for electrical compatibility. Obviously no components will have an 'E' until I build the board up and test it.