Indivision AGA MK2 Failure?

[DarkXavier]

Hi All,

I installed the indivision in my 1200 yesterday. Worked fine for about 2 hours connected via DVI and I also tried VGA, then had to go out so I switched the Amiga off. Later I thought I would try a DVI - HDMI cable as I want to use my pc monitor for my 1200, while having the pc connected by DVI. The cable didn't work so I tried the DVI cable, still nothing. So I tried a different monitor, not working with that either. Have tested the machine through RGB on my CM8833 and it works fine.

Any suggestions?

Thanks

[DarkXavier]

It's still seated fine. Looks like it is broken. :cry: Only trouble now is Amigakit's tech guy is off now until the 21St May.

[DarkXavier]

The seating meathod on these devices is similar to the accelerator I have in my 600. I had trouble initially with it even though it was seated right. So I removed the card and cleaned all the contacts on the cpu before reseating it. Maybe you could do the same with the chip that the indi sits on. Just use a bit of cleaning alcohol theb nake sure you seat theindi firmly after. It should make a lot of little clicks and creaks when seating.

Followed your advice and it now works again! Thanks! I feel like a idiot, should of thought of that. When it stopped working I just presumed the worst.