Welcome, Guest. Please login or register.

Author Topic: Dim Drive Light  (Read 8074 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline ElPolloDiabl

  • Hero Member
  • *****
  • Join Date: May 2009
  • Posts: 1702
    • Show all replies
Re: Dim Drive Light
« on: May 18, 2010, 12:52:21 AM »
If you want to test it safely get a set of leads that have crocodile clips on them. Have a crocodile clip and a probe plugged into the multimeter. Once you know which is the GND pin is put the crocodile clip on that. Then use the probe to touch the other pins. It won't slip around, so you won't short it.
Go Go Gadget Signature!
 

Offline ElPolloDiabl

  • Hero Member
  • *****
  • Join Date: May 2009
  • Posts: 1702
    • Show all replies
Re: Dim Drive Light
« Reply #1 on: May 18, 2010, 02:45:01 AM »
I can so good things about learning electronics and it is not hard to learn the basics. Learn Ohm's law, resistors, and then DC power supplies. It will give you the confidence to crack something open and replace fuses or clean up internals.
Go Go Gadget Signature!
 

Offline ElPolloDiabl

  • Hero Member
  • *****
  • Join Date: May 2009
  • Posts: 1702
    • Show all replies
Re: Dim Drive Light
« Reply #2 on: May 18, 2010, 03:01:05 AM »
double post
« Last Edit: May 18, 2010, 03:01:53 AM by ElPolloDiabl »
Go Go Gadget Signature!
 

Offline ElPolloDiabl

  • Hero Member
  • *****
  • Join Date: May 2009
  • Posts: 1702
    • Show all replies
Re: Dim Drive Light
« Reply #3 on: May 19, 2010, 04:56:37 PM »
It sounds like something is taking a lot of power. Perhaps your floppy drive is clogged with dust. Otherwise a component could be on the way out.
Go Go Gadget Signature!
 

Offline ElPolloDiabl

  • Hero Member
  • *****
  • Join Date: May 2009
  • Posts: 1702
    • Show all replies
Re: Dim Drive Light
« Reply #4 on: May 21, 2010, 03:55:22 AM »
It sounds like the floppy drive motor. You'll need a new floppy drive.
Go Go Gadget Signature!