Basic guide to install AGA mk2 config tool

[bbond007]

That's pretty much what I've read too. I'm actually kinda worried about bricking my IndiAGAMKII if I screw it up. Maybe search over at EAB http://eab.abime.net/ as there was a bit of discussion over there.

I don't think you will easily damage/brick the Indivision AGA MK2, as I have had early versions of the flash tool fail leaving the MK2 with no video. All I needed to do was switch to composite and reflash it again... Just make sure you have some secondary form of video.

Its just a little trial and error tuning it for your specific monitor, not rocket science.

[bbond007]

I found on my samsung what worked best was to make some custom modes with the VGA tool:

724x480@65 -> NTSC MODES
724x580@72 -> PAL MODES

Hope that helps....

[bbond007]

No luck. I try putting all the files in the ram disk and also in the original folder but I get the following error message on the shell: install: file is not executable

try protect +s [fileName you are trying to run]

then try again, that tells AmigaDOS its a script.

if its an exe then protect +e [fileName]

hope that helps. good luck...