A1200 HD activity light (not CF related?)

[bbond007]

So I had a CF HD in the amiga for a year or so, HD activity LED worked fine with this device.  Installed my ACA1232 last weekend, I'm pretty sure the light was happily blinking away after that.

Then I took the entire thing apart to get at the back of the mobo and remove a couple of capacitors, which went perfectly smoothly and fixed up my timing issues pretty much with the 1232.

After re-assembling and booting I have no power going to the HD LED at all :confused: I've tested it with a multimeter while accessing the drive and nothing so its not the LED itself.

Just wondering if its a side effect of the timing fixes (seems unlikely) have I damaged something else or is there a usual suspect I should look out for. I haven't yet taken the board out again to inspect it but what should I look out for when I do?

Thanks.

I'm pretty sure that the CF card gives power to the LED.

That is why when you install  fastATA  you run wire to  that pin on the old Ide header.  Maybe try different CF card.

[bbond007]

well it worked fine with the exact same cf card and interface for months, one rebuild later it doesn't work... seems like it might be something else to me, either way I don't have a spare card handy to test it out.  do you know what pin that is?

http://www.ntrautanen.fi/computers/hardware/misc/amiga_ide.htm pin 39 then? thats at the upper right if i'm looking at the 1200 from front on presumably?

Well something died,  and it has to be the LED,  MB trace,  or the CF..

That diagram is for 40 pin (Not 44) . As I recall it's 3rd down from the top right. Just check Fast ATA info. Pic 10.

http://www.elbox.com/ma/fa_1200_folder/fast_ata_1200_qig.html

[bbond007]

Hope you get it fixed. Does sound like a loose wire to me, or you've connected the activity wire to the wrong pin on the internal IDE.

I don't think he has a FastATA(activity wire) I was just using that page to show which pin goes to the LED. I think that pin should have continuity with the LED.

I think most likely its a bent/broken pin or the CF card malfunctioned and quit putting out that signal.

My LEDs on my PCMCIA Wifi card quit working for some strange reason. I suspect maybe the card got slightly bent.. I thought my PCMCIA port died.