Putting a 2.5" HD on my A1200

[ptek]

Hi all

Currently I have a A1200 which I must say I don't boot for at least one year due lack of space on the room mostly.

The other reason is that my currently HD become temperamental, maybe due to improper power wiring. That is, it's a 3.5" old HD connected to the 2.5" slot by a cheesy homemade cable but the power is taken from somewhere else (I think it's shared from the floppy power... i'm not sure).
Anyway, the 3.5" HD is fine since when I connect to the IDE of my PC is starts to spin and it's acessible under WinUAE.

So, back into subject, since 2.5" HD are relatively cheap and quiet nowadays i'm thinking of buying a 20GB or 40GB seagate model (i don't any of that need huge space!) and fit it inside de A1200.

So my question is : will I need any cable for power or the cable from Amikit like this ( here) will do the work ?

My other option would be a SD card to IDE adapter but i'm still investigating this here on the several amiga.org threads.

[ptek]

But do you still have the harddrive cradle? Like this one?

It's a good idea not to let the harddrive float around.

Well I'm not sure... I think i don't.
So that also raises a question : is that cradle supports current 2.5" drives ?
I realised that nowadays 2.5" HD are slimmer than old ones ...

[ptek]

by amigakit on 2007/5/19 16:44:20

If you buy a drive+bracket from us, we can pre-drill the bracket on your request at time of ordering.

With no additional cost ?

Anyway, I think drilling will not be a problem to me.

BTW : Maybe I'll go for the

4-Device Buffered IDE Interface

As far I understood, this replaces the simple 2.5" cable and gives further expansability and buffered transfer which is an extra.

Is the IDEfix97 in the Aminet fully freeware or does it need any registration in order to unlock any features ?

[ptek]

the 4-Device Buffered IDE Interface allows the HD to remain inside the A1200 right? That's one of the reasons I have to buy a 2.5" drive.