Configuration ?

[stanlong]

My A2000 has the standard CBM A2091 HD board 2Meg fast onboard
Boot roms 6.6 roms sys2

I have a GVP A2000 SCSI +8 board  4 Meg fast on board
I think the  Boot roms GVP V1.0 ODD 69D9 GVP V1.0 even 1A3B
Q.
apart from the extra ram and using bigger capacity HD would there be any advantage in swapping the Hd control boards?

Also have a AT Parallel Serial adaptor flytech 8608030 v4.1
What is its primary use? :-?

[stanlong]

i see on ebay GVP series 11 scsci Rom V4.15 upgrade is this the last upgrade they released for this board.
As there appears to be two on the board one labelled  
GVP V1.0 ODD 69D9   the other GVP V1.0 EVEN 1A3B
which one would I be replacing they only offer one as the upgrade
also can I test the board without a hard drive?

[stanlong]

A2000-SCSI+8 REV 1
GVP V1.0 ODD 69D9  GVP V1.0 EVEN 1A3B
it has the  WD 33C93-PL controller IC
and exactly how do i configure your configuration

[stanlong]

SCSI+8 is SCSI I board

And if you have A2000 SCSI+8 board, It looks like rom 3.15 is the last one for this board.

And the bord do use 2 roms. So you have too burn yourself.

So atm you are best off whit the bit slower 2091 SCSI card.
And use the GVP as ram card.

you find the information about this at this page:

BuzzBrain

and exactly how do i configure your configuration

A2000-SCSI+8 REV 1
GVP V1.0 ODD 69D9  GVP V1.0 EVEN 1A3B
it has the  WD 33C93-PL controller IC
and the stock standardA2091