Have a very wavy picture and horizontal lines running up the screen. Occasionally a pink flash.
If I connect the Amiga 500 plus back up with the s-video it's fine.
I have removed the Indivision and checked all the pins, have checked the riser card.
Have pushed it in as far as I can get it to go and appears to have no gaps, the pins are all where they are supposed to be, have installed the ground cable.
Have tried without the ECS Denise. The Amiga 500 plus is a full ECS machine so can't see any issue there.
Have stripped it down to just the motherboard and the indivsion connected and still the same thing.
Installed the Indivision config tool as I have a funny jagged missing gap at the bottom which is apparently normal on some monitors. Still same problem.
Have googled around and found one guy having the same issues and I got the impression he pushed it so hard the board bent to try and get it to work.
Not sure what else to try :-/ The most money I've spent on an Amiga LOL :-)
]
A few years ago I bought the Indivision ECS and I had major troubles. I could not get the damn thing to work to save my life. My mouse wouldn't work correctly, icons were distorted and other strange things were happening. In fact I was about to sell it on ebay just to recoup back some of my money.
Solution: I realized the thing was not seated all the way. Initially I tried and tried to seat it as far as I could but the problem was still there. Finally, I said thats it!!! I lined the pins up pushed the chip hard as hell until it slid into place. Check out this thread I started a few years ago regarding the problem I was having. Hope it helps.
http://www.amiga.org/forums/showthread.php?t=52706Barney
