Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: HDToolbox: What should the "Mask" setting be set at?  (Read 6813 times)

Description:

0 Members and 2 Guests are viewing this topic.

Offline barneyTopic starter

  • Hero Member
  • *****
  • Join Date: May 2008
  • Posts: 555
    • Show all replies
HDToolbox: What should the "Mask" setting be set at?
« on: September 30, 2011, 02:11:57 PM »
I accidentally changed the "Mask" value on my partition in HDToolbox.  I have a GVP 68030 card/accelerator.  Does anybody know what the typical setting this should be set at?  Thanks.
Logged
 

Offline barneyTopic starter

  • Hero Member
  • *****
  • Join Date: May 2008
  • Posts: 555
    • Show all replies
Re: HDToolbox: What should the "Mask" setting be set at?
« Reply #1 on: October 01, 2011, 12:34:48 AM »
The hardware I am using is as follows: GVP 68030 SCSI / Accelerator card w 16mb GVP RAM.  Hard drive is a 2.1 IBM 50 pin HD.
The reason I am having trouble is because when I went to change my Max Transfer, I accidentally changed the Mask instead.  Now my mask reads: 0x1FE00 and my Max Transfer reads: 0X7fffffff

Do these numbers make any sense?  By the way Zac67, I tried 0xFFFFFFFC  like you suggested but it didn't take (would not allow me to save).  Any more number combonations you might know?
« Last Edit: October 01, 2011, 12:35:27 AM by barney »
Logged
 
Pages: [1]   Go Up
« previous next »