Bsc Tandem ide+cd installation

[Thomas]

On WB 3.1 there is a command called ShowConfig which lists all expansion boards recognised by the system. I didn't find a similar program on WB 1.3, so I wrote this: http://thomas-rapp.homepage.t-online.de/download/showboards.lha

Run it and look for a board with Vendor=082c and Product=06. This is the hardware the AT driver binds to (see icon information -> tool types).

Only if the hardware is recognised, the driver will load and initialize.

[Thomas]

But it was alive few days ago. Perhaps you can clean contacts to make it work again.