Can OS3.9 patches run fully on an A4000D?

[davideo]

@Vanilla

I've got a similair set up to you.

There are two major differences though.

I boot from my IDE drive with an external SCSI CD drive on the Warp.

OS3.9 +BB1&2 were installed before my Warp.

The system booted ok before and after the Warp was fitted.

So your setup should work without fault!!

Dave G ;-)

[davideo]

Perhaps the SCSI booting is stuffing it up. Actually IIRC I have a wide SCSI HD. My friend done that for me and it needed an adaptor, and I could get a HD light line off it. Perhaps that could be interfering? Check my SCSI config?

It might be worthwhile checking your SCSI termination but if it booted prior to installing 3.9+BB1&BB2 then it shouldn't be the termination causing a problem.

Have you tried an IDE hard drive?

Dave G