Hello amigans!
I have a little problem and I've thought of you t
try to figure out the cause of this problem I have
in my setup. I have a PowerFlyer EIDE controller
and it works fine as long as I use PIO4 Mode,
I have Pio5 (4NF) capable hardisks but when I switch
to this PIO4NF mode I start getting checksum errors
and file corruption. The harddisk access is faster
but it corrutps everything... I don't know if
my IDE cables suck or if this is a compatibility
problem with my accelerator (BlizzardPPC). I thought
of contacting elbox regarding this problem but
also thought of asking you here before :-)
Does anyone have the powerflyer working with
harddisks in Pio4NF modes without file
corruption? My config:
A1200T BlizzardPPC 060/50, 603e/240, SCSI,
128 MB RAM, BVision, ZIV, HighwayUSB,
Xsurf, varIO.
Thanks!
Daniel
