Deneb 2.0 Working sort of

[Tumbleweed]

Hi all,

I've the Deneb installed and working sort of. On bootup I get a recoverable alert, which I can click through to boot into OS3.9.

I can get my USB zip drive working on the internal USB port on the Deneb board, but when I move it to the external ports - the two connected by cable to the board, the drive disappears. I've also tried a USB flash drive and its the same thing, shows on the internal but not the external.

Any ideas?

A4000D OS3.9, Cyberstorm MKII 060 128MB, CV3D, X-Surf 3c, Deneb 2.0.

[Tumbleweed]

Heck hope I've not knackered the card. The internal port works fine. No problems there.

I tried updating to V4.2 of poseidon but after installing I get requires at leas V4.2 of poseidon.library error and can't go any further.

Where do I fin the latest library? I1ve downloaded the latest archive using Poseidon.

[Tumbleweed]

Thanks. I've nNow got Poseidon V4.2 installeeed and working. But still get a recoverable alert at boot-up. Also have checked cable connections for the external USB ports, both cables are right way round.

The internal port works without any problems. I've just installed an internal card reader (ripped from my PC) in the desktop case after modifying the front facia to get it to fit and it works perfectly.

Just need to get the external ports working and sort out the recoverable alert on boot-up.

[Tumbleweed]

Thanks Darrin. Updating the firmware on the Deneba and then powercycling has done the trick. No recoverable alerts on boot-up, now.

Is there a way to get rid of the Deneb start up intro? Remove it from the Flashrom using Luciferin?

What else can the flashrom be used for?