Welcome, Guest. Please login or register.

Author Topic: minigl on classic_os4_mediator_voodoo3  (Read 3003 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline wawrzonTopic starter

minigl on classic_os4_mediator_voodoo3
« on: August 03, 2008, 02:46:42 PM »
i installed the minigl package from os4depot onto my very fresh basic os4 classic partition, but nothing seems to work. demos or for that matter blankers i downloaded either do not start or mostly give me recoverable error in an endless loop.

is that possibly due to my hardware setup i mentioned up in the thread subject?
 

Offline wawrzonTopic starter

Re: minigl on classic_os4_mediator_voodoo3
« Reply #1 on: August 03, 2008, 07:17:45 PM »
im using mediator4kdi in a regular a4k desktop. i run elbox libs 4 voodoo and pci since i use network card on pci. i just installed minigl and do not tried much else although i downloaded warp3dwrapper before (i think thats what w3d appz need to run under os4) and tried some demos from ada, what didnt function.

i must admit i havnt succeed to get w3d to run under 3.9 on the same system earlier, even if i recall it working before i put ppc in it, that means probably before the warpos installation, but thats another story..
 

Offline wawrzonTopic starter

Re: minigl on classic_os4_mediator_voodoo3
« Reply #2 on: August 03, 2008, 10:58:32 PM »
aww!! i havnt realized voodoo3 does only 16bit in 3d mode. also my workbench res might be too high. i usually use 1280x1024 in 24bit. sounds like i ve been expected too much from the hardware. 3.x w3d demos open mostly their own screens as far i recall, but i assume gfx mem stays occupied with other open screens so maybe it overflows or such. lemme check that when back @ home. otherwise i will probably really try to swap the drivers.
 

Offline wawrzonTopic starter

Re: minigl on classic_os4_mediator_voodoo3
« Reply #3 on: August 04, 2008, 07:50:58 AM »
well, i havnt much time nor attention today morning but as far  as ich checked the prob is not an issue of screen resolution. what i noticed so far is the system reports mostly an 80...03 guru. and after short soft_reset the machine hangs with a lila screen on rgb what i suppose to be some sort of debugging message on classics.

salute u, we going to bed (in the morning)!
 

Offline wawrzonTopic starter

Re: minigl on classic_os4_mediator_voodoo3
« Reply #4 on: August 04, 2008, 06:35:17 PM »
you were completely right. minigl runs on original os4 drivers. quite impressive for an amiga. lol. if only it would work with elbox because i must rely on their architecture for my purposes. i will look into that
 

Offline wawrzonTopic starter

Re: minigl on classic_os4_mediator_voodoo3
« Reply #5 on: August 14, 2008, 05:19:41 PM »
@hans_:
they havnt reported back on this matter up till now. i do remind them now and maybe will be just calling them next days (they are most supportive on the phone.lol). i work on 3.9 at the moment so it went a bit off my focus.