@NIck2K4
The correct site to do it is the TP1 connector un the very 1200 mainboard.
Just near the PCMCIA connector, you will see two marked connector on the board, labeled as TP1 and TP2.
They are marked on the board, but no connector is soldered onto it.
In the TP1 connector, the 2 leftmost contacs (the nearest to the pcmicia) are the reset contacs.
Just solder a jumper to them, and later, connect your towers reset switch to it.
You have just done a hard reset switch to the 1200 main mobbo.
Any Questions?
