FastATA 1200 can't boot anymore

[kreciu]

I reattached my FastATA yesterday and I can't boot anymore from my HDD. I only can see screen with floppy and I can boot from floppy disc. I also can reset computer with reset button on FastATA. Power wire for FastATA is attached. Everything work "before".

Do you have any idea what should I do?

[kreciu]

"Before" what?

I added empty ROM sockets to make more space under FastATA. HOWEVER, this issue was there before adding this sockets (once in a while), so it is not sockets itself AND Amiga works fine... so it is not ROM issue.

Every time (somehow?!) it worked after "touching motherboard for a longer time"... but I don't know what this issue is about. I just can't figure out what is wrong with this FastATA. When it works, it works fine.

Main reason I did it was to add Lyra keyboard interface to use my PS/2 keyboard vs. very old DIN keyboard.

BTW. Now my CF card is dead and I can't even set up new system , very happy week for me.

[kreciu]

It works now. Lyra under Fast Ata and all under Mediator .

[kreciu]

Ok. I have not idea what is causing this issue. I just replaced motherboard installed everything as it "should be" and SAME ISSUE as before. I can just see initial screen with floppy and nothing is happening (like HDD is not detected).

I disconnected Blizzard and problem is still there. I really don't understand what is happening.

Do you have any ideas?

[kreciu]

Are you certain that the FastATA is pushed down into the ROM sockets all the way and correctly located? Sounds like a connection issue, especially when you mentioned the time factor and how after a while it can sometimes work - which could also suggest a power issue due to poor caps or power supply. Also, seems silly but check the IDE cables that you're using are fitted correctly and not pin shifted (happens to us all at some point).

Yes, I can see ROM version, initial screen with floppy disc, so ROM is attached properly. It is something else?! I really don't know. Power supply is ATX 350W and caps are "fine" (soon I will try with new one).

[kreciu]

I  tried... and I have the same issue without riser. It made me so mad now I using 4xEIDE (1MB/s...). I'm not sure how long I will survive this speed.

I have ONE suspicion. I added only one layer of ROM sockets and still Lyra2 is bending FastATA "just a little" (yes, I put something in between ), so maybe this would be a reason.

I think I need different keyboard interface... Why Lyra is so THICK, my previous DIN keyboard interface (made by  Elbox) was super flat and worked fine without any riser (also bent "a little")

No, hard drive is not visible in early startup . It is like it not there?! I can boot computer from floppy drive and this should not be ROM issue. This is my newly recapped motherboard so caps are also fine (as someone suggested before).

BTW. I can't take anymore English grammar .