Fastlane Z3 SCSI

[Miloo]

Has anyone had trouble with using the CSPPC SCSI and Fastlane SCSI together?

With the Fastlane plugged in, the CSPPC SCSI isnt detected and nor are the HDs plugged into it. Without the Fastlane the CSPPC SCSI detects the HDs.

My Fastlane has the 8.5 revision ROM so its all correct for the 060 cpu.

Any ideas?

[Miloo]

With the Fastlane plugged in, the HDs on the CSPPC SCSI bus are not detected in the Phase 5 SCSI program.

On the Fastlane is a CDRW drive because it isnt detected when I plug it into the CSPPC SCSI bus (I tried a 50 to 68 pin adaptor - didnt work).

There is a HD on the CSPPC SCSI bus.

When I load the Phase 5 SCSI utility with BOTH the CSPPC SCSI bus and Fastlane plugged in only the CDRW on the Fastlane is detected. The CSPPC SCSI bus doesnt show (only shows if I take OUT the Fastlane.

[Miloo]

Yes it boots with the Z3 attached and I boot from the mobo IDE HD.

I want to use the CSPPC SCSI bus to boot from and remove the IDE HD.

[Miloo]

Its a 4000D in a tower.

Moving it to any slot doesnt work at all, when I load the SCSI program the Fastlane comes up as board 0 and when I take out the Fastlane the CSPPC SCSI bus comes up a board 0 as well.

So it looks to me as the Fastlane overrides the CSPPC SCSI bus somehow?

[Miloo]

Update

Ive got a OS3.9 emergency disk setup and I can see the CSPPC SCSI bus and Fastlane bus.

The CDRW on the Fastlane is ok but when I use OS3.9 HDToolBox to use the HD it says this device cannot be handled by HDToolBox.

So how do I use the HD, as the SCSI unit control program doesnt see the CSPPC SCSI bus only the Fastlane bus?

To recap

SCSI unit control can see the Fastlane bus but NOT the CSPPC SCSI bus.

OS3.9 HDToolBox can see BOTH the Fastlane Bus and CSPPC SCSI bus but cannot use the HD.

 :crazy: