Bumped because Erol and Tahoe still haven't got back to me about their disk module revision numbers, which I think I deserve
Well I got an A4000T a week ago and the first thing I did was pop it open (clean it) and check the disk module revision number, down side is its a revision 1, as is a spare I also bought from Vesalia.
Now Ive got to do some touch-up on the paint work, anyone got any hints on a good paint to use?
My A4t is a late Escom one and the door is missing.. anyone know if some company out there still has a stock of front facias for the Enlight Case?
Also at the moment my Cyberstorm is dead (been like that for a few yeras, I will get it repaired after my finances recover) but in the mean time Im using the A3640, problem is the revision 3.1 card wont boot, the LED goes dull then bright but then stops but my 3.0 board works just fine except I have had to remove the heatsink that was on it as it doesnt fit under the metal carrier with it on... so any hints on a: why the revision 3.1 board aint working (Ive changed the CPU on it for the 3.0 chip and get the same) and if revision 3.0 cards are ment to get so hot it crashes. (Could be a timing problem with the 3.0 card but it works fine when it starts, then reset or something and you get errors like iprefs have crashed or a guru etc)
hmm I gotta go looking for more of those slides too.
