Buddha IDE controller hangs with Cybervision card installed

[mbrantley]

My Buddha IDE controller card arrived today from Amigakit, and after some trial and error I have found that the A4000 won't boot with this card and my Cybervision 64/3D graphic card installed at the same time. If I remove the graphic card (not gonna happen permanently!), the machine boots and the Buddha card functions.

Any notion what the problem is? I'm using Cybergraphics 4 to drive the graphic  card, by the way.

Thanks!

[mbrantley]

One of the brightest spots about me "new" old Amiga: It's got a Buster 11 chip in it.  

[mbrantley]

Hmmm. Indeed, I am running a 3640, but I'll have to check to see what version of it. This is temporary, as I plan to put in an accelerator board when I can find one. The only other "weirdness" I'm having is that VistaPro 3.0 will absolutely not run with the CV 64/3D card in my machine, even though I am not trying to mode-promote the program and am just trying to get it up and running on the native display. (I understand VistaPro and RTG do not mix.) The program works fine (like the Buddha!) when the CV 64/3D is pulled from the machine. Otherwise, no issues whatsoever with the graphic card.