4000t CSMKIII 060 question

[amesie2]

I have one of these accels in a 4000t and am wondering why I keep getting a GURU everytime I try booting my system?

I did install the software as it says before installing the accel. in my system. The board has 128M on it and 16M on the motherboard. I don't have any other cards installed.

I did find that when Setpatch is commented out it will boot or if I use rom2fast before the Setpatch command it will also boot. What gives with this board? any help would be great.

[amesie2]

How do I get into the CS bios settings? I have been trying to figure this out for a while.

I am using the 4000t SCSI only I haven't tried the CS SCSI yet.

Thanx for the reply

[amesie2]

I am not sure of the version rom I have I will have to look, I am using 68060 libraries from OS 3.9.

I will have to try removing the onboard memory and see if that helps.


Thanx

[amesie2]

I tried this already and nothing happened other than the system booted up.

I also tried holding the esc key after a reset and still the system just boots up.

[amesie2]

OK, I flashed the card to the latest update from the phase 5 sight, now when I press ESC on startup I do get a screen that comes up but it is scrambled. I booted the computer up and noticed in the screen mode settings there is a new monitor setting installed (BootVGA:productivity). I set my monitor to this setting (1084S) to see the result and sure enough the monitor did the same thing as when I held the ESC key on start-up.

Is there some way I can change the screen setting for the CSMKIII setup screen? if I can't I will have to get a scan-doubler or something to be able to see this early start-up.

Thanx again for the support.