* SOLVED * SCSI hdd don't automount

[derringer3]

Hi Folks!

I have a problem with my scsi hdd. I recently got a quantum atlas 10K 9GB Hdd. I connect it with my blizzardppc card. First no luck, I tried all the possible versions and wariations of hdtoolbox. (yeah i gave blizzppc.device to search for the drive.)But nothing happened.

Then i try cyberscsi pack. there is two program  and one of them an option to rescan the device. It showed the correct hdd, and i can mount it with a button. Only then i can  partition any software. (hdtoolbox etc.)
I tried sfs ffs but my problem is that no matter what  i write on it the system only sees this hdd when i use the the program of the cyberscsi pack. (rescan drive and mount) I check the button of auto mount drive when i partitioned it.
So what will be the solution?

[derringer3]

Half succes. I managed to automount the drives, and it can boot the os, if i disabled the ide hdd in boot menu. But when i take out the old ide drive from amiga, the scsi hdd don't boot.
I got an illegal operation yellow lined Guru message with the following numbers: 0100 009 44003560

Now what?

[derringer3]

Ok I lowered the boot priority, so i don't need to set in early startup menu. All is working fine. (scsi and ide) But the problem not solved.
I using SFS all partition. (SCSI and IDE)

Put filesystem in rdb? I added/loaded sfs filesystem, when partitioned to all of the partition, not just set it custom/sfs. Or any more work need to be done?

So when i switch off my IDE drive and only my scsi drive present (or and my dvd-writer drive on ide) the system is still hang before my miggy begin to start-up.

[derringer3]

Yeah same version of sfs

[derringer3]

Finally I solved the problem. I wanted to back up my system, and deleted all of the partition from the IDE hd. My scsi hd won't boot.... So the problem is my "old" ide hd had correct sfs partitions and the system could read the sfs data from the rdb of my ide drive. Since my scsi hdd was not correctly partitioned, (Now i know it) the system can't load the data of sfs because it was nowhere. So the system crash.
I partitioned my old ide to sfs  under winuae, and then i can boot up my system again in real amiga. The deleted the sfs filesyystem under hdtoolbox, and added again.
I think the problem was i mismatched the sfs hex numbers, so i set it correctly now. And finally my scsi hd  working without the presence of my ide hd.