Blizzard 1260 problem

[madgoblin]

I've just got an 1260 from a succesful bid on ebay, but now i have a "little" problem trying to make it work :S
The card is identified on the early boot screen, the memory is reported (64mb edo ram) and everything is fine until i install the 68060-V44_3 package from aminet.
After i install the libraries and reboot, it returns a guru when running c:version (guru 8000 0003). If i run it without the simm, boots normally:S
If i try with a 16mb edo simm gives the same error, so i'm not sure that is a memory issue.
And one more thing, the mainboard is an 1D4, but i have done the "fix" removing both capacitors...

Any idea?

Pd> sorry for my bad english

[madgoblin]

Ok, downloaded and installed ...
right now i have the following versions in libs:

68040.library   46.5
68040new.library   46.5
68040old.library   37.30
68060.library 46.7

But i'm still getting that guru  :boohoo:

[madgoblin]

It's strange because if i boot without startup-sequence, and then execute setpatch, i can run 060 demos without problems :S but when booting normally i cannot get past the version command
(i have tested starstruck and tint / tbl)

[madgoblin]

Crumb wrote:
you should install the smallest 68040dummy.library and rename it as 68040.library and also the bigger 68060.library.

Done

Installing MuRedox/Oxypatcher/Cyberpatcher may be a good idea too.

I will try that tonight

Check out which datatypes do you have installed.

Its a fresh installation (wb3.1) the only thing that i have installed is the "driver" for the compactflash-pcmcia adapter.

[madgoblin]

i have discovered that if i boot with the cache disabled, it boots normally.
Any idea so far?

(yesterday i tried to run cyberpatcher, but it still crashes )

[madgoblin]

Let me see...

The cpu is an 060RC50, and with the libs installed and running cpu060 it's identified as 68060MC

[madgoblin]

Well, finally i've got a 1B revision from amigakit, and it's finally working!!!!!!

\o/
Thx you guys!
 :-D