A600 wiring repair question

[BGary335]

I have an A600 that is in need of a few repairs, one of which is that the wires that power the hard drive, floppy, and power LED's on the case need to be soldered back onto the circuit board inside of the top half of the case. Problem is, I don't know whether each color wire on the connector has to be attached to a certain place on the circuit board. So my question is, is there a particular way it needs to be done, and if so, what is it? I've searched the net for info on this, but have come up pretty much empty handed.

Thanks in advance for your help!

[BGary335]

First, I appreciate your help. Let there be no confusion about that.

That said, I apologize if my request was too much. I'm sure someone else here would have been able to  provide the needed help sooner or later. I'm a little shocked to be seeing the rolleyes smilie over such a minor request. I hope I'm just taking it the wrong way.