I have just been going through the same problems as this thread describes. I couldn't get a Cyberstorm MKII to work in an A3000T 040. The A3640 worked fine, but the MKII did nothing. It took me awhile and a lot of testing but I finally got it to work today. I put a 74F08 chip in U103 which was empty. This alone did nothing. I then changed J100, and J104 and presto, the computer tried to boot. I then mounted the new libraries for the MKII and rebooted and I finally had it working. Now for my question. I did nothing with the J105, J106, & J107 jumpers. They had no jumpers on them and still don't. I have read here and several other places that all three should be jumpered on pins 1-2. There is also a post earlier in this thread that says they should all be jumpered on 2-3 and never changed. Could someone give me some help with this? Is it fine like I have it with no jumpers at all (which is how the computer already was), or put jumpers on all 3 and what pins should I jumper? By the way, I changed J100 to 1-2 and J104 to 1-2. Thanks,
Dan
